Differences

This shows you the differences between two versions of the page.

--- hardware:modules:mod-hry2 [2012/08/10 01:25]
aaron created
+++ hardware:modules:mod-hry2 [2012/09/07 04:34] (current)
jarrod
@@ Line 1: / Line 1: @@
 ====== MOD-HRY2 ======
+The MOD-HRY2 is a modular unit with 2 x 250VAC 15A Latching Relay ports.\\
+This module can be used to switch high amperage loads directly.\\
+Latching relays will remain in their open or closed state on power loss, allowing loads to return to their previous states without interruption.
+<WRAP important round 50%>
+=== Max Load per Relay Channel ===
+VAC, 15A
+</WRAP>
+===== Ports =====
+Front of the module has four captive screw terminals, allowing for large gauge wiring.
+**Pinout**
+  - Port 1 +
+  - Port 1 -
+  - Port 2 +
+  - Port 2 -
+===== Rear Connector =====
+The rear of every module contains a module port, used to connect the module into the modular controller base unit (DIN-MOD4, etc). The pinout for this port is not published.

CommandFusion Wiki